Back

Technical tip for Automatic Inspection Machines: Procedure for Spin Cap Portion Assembly Installation

Expertise Series

This is a tip from Sean Willis for making adjustments to fully automatic machines that spin containers.

Note – Cap portion assembly must be pushed into uppermost position when adjusted or replaced.

  1. Loosen set screw on side of bushing and push assembly up to limit, then tighten set screw while held in this upper position.
  2. Compare to caps on either side of the one being adjusted to be sure they are at same position and level with each other

 

Esai

 

Top of page

Cookie Preference

Please select an option to continue. You can find more information at help.
Privacy Statement | Imprint and Legal Note

The selection is saved.

Privacy statement

Help

To continue, you have to select your cookie preference. Please find below an explanation of the different options.

  • Accept all cookies:
    First party tracking and analytic cookies are set. Read more about our cookie policy in our Privacy Statement.
  • Reject all cookies:
    No cookies except those neccesary for technical reasons are set. Read more about our cookie policy in our Privacy Statement.

You can change your cookie setting here anytime: Privacy Statement.

Back